Simer Pumps 3410P Manuel d'utilisateur télécharger pdf (Page 6)

Electrical 6

For parts or assistance, call Simer Customer Service at 1-800-468-7867 / 1-800-546-7867

MOTOR SWITCH SETTINGS

Dual-voltage motors (motors that can operate at either

115 or 230 volts), are set at the factory to 230 volts. Do

not change motor voltage setting if line voltage is 230

volts, or if you have a single voltage motor.

NOTE: Never wire a 115 volt motor to a 230 volt line.

REMOVE MOTOR END COVER

If you have a dual-voltage motor, and will connect it to

115 volts, follow the procedure below.

You will need to remove the motor end cover to change

the voltage setting.

Your motor terminal board (located under the motor end

cover) should look like Figure 4.

SELECTING VOLTAGE WITH DIAL TYPE

VOLTAGE SELECTOR

To change to 115 volts:

1. Make sure power is off.

2. Turn the dial counter-clockwise until 115 shows in the

dial window.

3. Attach the power lead wires to the power lead termi-

nals. Make sure the wires are secure.

4. Attach the ground wire to the green ground screw

5. Reinstall the Motor end cover

Go to Wiring Connections below.

Hazardous voltage. Can shock, burn, or

cause death. Disconnect power to motor before working

on pump or motor. Ground motor before connecting to

power supply.

Figure 3: Removing Motor End Cover

Motor

End Cover

End Cover Screws

Figure 4:Voltage set to 230 volts, Dial Type; turn dial to

select 115 volts.

Power Supply

Terminals

Ground Wire

Terminal

For 115 Volt

For 230 Volt

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Pas de commentaire

Simer Pumps 3410P Manuel d'utilisateur Page 6